TTW Air ConditionerThank you for choosing our product.For proper operation, please read and keep this manual carefully. 26TTW09AC115V1A 26TTW09HP115V1
10AIR CONDITIONER FEATURES (continued)::TO CHANGETEMPERATURE SETTING: :PRESS ON/OFFBUTTONPRESS TO RAISEPRESS TO LOWERTO USE AUTO FAN FEATURE: PRESS FA
11CHOOSEPRESSMODE BUTTONFAN ONLYTHE TIME CHOSEN:FIRST DO THIS:PRESS TIMER BUTTONNote: Use this function only when cooling is not desired, such as for
12AIR CONDITIONER FEATURES (continued):If the display reads F1a sensor has failed.If the display reads F2a sensor has failed.If the display reads
13ADDITIONAL INFORMATION• The remote control will operate all the control panel features.Instructions will be the same.• The “COOL” circuit has an aut
T2600 SeriesThrough-the-Wall Air Conditioner Limited Warranty ONE-YEAR PARTS AND LABOR LIMITED WARRANTY – During the first year after origina
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.Edition Date: 11-14GREE WILL NOT BE RE
66129917060 Gree Electric Appliances, Inc .2015 All rights reserved. Cat No. 26-TTW-1OM Version 1.0
2TABLE OF CONTENTSImportant Note to Homeowner... 2Important Note to Servicer ...
3VOLTAGE MEASUREMENTSBefore connecting the unit, measure the supply voltage. Voltagemust fall within the voltage utilization range given in the follo
4Figure 33. Remove shipping pads inside air conditioner next tocompressor. (See Figure B.)RemoveshippingpadsFigure B4. Carefully slide the chassis int
5To open or close the vent:1. Remove the front grille.2. Remove the vent card screw.3. Remove the vent card, turn it over and replace it by locatingre
6WIRINGBefore wiring the unit, please review the following warningsand cautions.
ON/OFF7ON/OFF buttonMODE button+/- button FAN buttonTIMER buttonSending signalTimer on Timer offlockset speedSet temperature Set timeheat operationf
8AIR CONDITIONER FEATURESNotice:• When power is connected (stand by condition), you canoperate the air conditioner through the remote control.• When u
9Note:• Range of time setting is: 0.5~24h.• The interval between two motions can’t exceed 5 sec-onds, otherwise the remote control will exit setting
Comments to this Manuals